MCZ Boxsystem 75 FR - Manual (Page 27)

Chapter 5
INSTALLATION AND USE MANUAL
page
27
Operation Technical service – MCZ S.p.A. all rights reserved - Reproduction prohibited
5. OPERATION
5.1. PRE-LIGHTING WARNINGS
Make sure you have read and completely understood the contents of
this instruction booklet.
Remove all accessories and supplies which might burn (various
instructions and adhesive labels) from the firebox and door.
Remove the stickers from the ceramic glass or the high temperature
could melt them and irreparably damage the glass. In this case, the
MCZ warranty does not cover the glass.
Avoid touching the product the first time it is used since its
paint completes drying and hardens during the first lighting.
If you touch the paint, you may expose the steel surface.
It is good practice to provide plenty of ventilation in the room
during the initial lighting, as the product will give off a small
amount of smoke and smell of paint.
If necessary, touch up the paint with aerosol spray in the
original colour. (see the section "Accessories for fireplace
stoves and inserts").
Do not remain near the product and, as previously mentioned, ventilate
the room. The smoke and the smell of paint will vanish after about one
hour of operation. There are no health risks involved.
The structure will be subject to expansion and
contraction during the lighting and cooling down
stages, and may therefore make slight creaking
noises.
This phenomenon is absolutely normal, the structure
being made of sheet steel, and must not be
considered a fault.
It is extremely important to be sure not to take the
product to full heat straight away, but to bring it
gradually up to temperature.
This avoids damages to seals and the steel structure.
Do not demand full heating
performance straight away!
5.2. FUEL
FUEL: Wood
To obtain the maximum performance from your product, it is of primary
importance to use wood with suitable characteristics.
It is possible to use firewood such as oak, beech, ash, robinia or
ilex, or manmade logs from compressed wood without added resins.
These have a high calorific value and must be used with
caution to avoid overheating which could damage the product.