MCZ Scenario Forma 95 GAS Left - Manual (Page 17)

INSTALLATION AND USE MANUAL Chapter 2
SCENARIO pag. 17
Chapter 2 Technical service – all rights reserved by MCZ
GROUP spa. Reproduction prohibited
3.9. ASSEMBLING THE PLASTERBOARD CLADDING
PLASTERBOARD HOLE SIZE (2000mm x 670mm):
Y= H – 133 -> H = measurement taken from the floor to the lower part of the frame crosspiece (figure A).
-> 133 = minimum measurement (with feet completely screwed).
Z= P – 46 -> P = measurement taken form the existing wall to the rear frame upright (figure B).
-> 46 = minimum measurement required by the wall locking brackets.
Using the formulas shown, calculate the height of the plasterboard wall hole from the floor and the distance of
the wall from the original wall. To reinforce the hole on the wall use uprights (M) with a maximum depth of
30mm.
A B