MCZ Toba HYDRO 22 - Manual (Page 22)

20
4 - UNPACKING
PREPARATION AND UNPACKING
The packaging consists of a recyclable cardboard box according to RESY standards, recyclable EPS foam inserts, wooden pallets. All
packaging materials can be reused for similar use or disposed of as urban solid waste, in accordance with current regulations.
After having removed the packaging make sure the product is intact.
Handle the product with suitable means paying attention to the applicable safety regulations in force. Do not turn the
packaging over and handle the ceramic parts with care.
The TOBA stove is delivered complete with all its electrical, mechanical, and hydraulic components after it has been tested in the factory:
Remove the supports, cardboard and polystyrene. Put the box somewhere safe with the decorative front of the stove and proceed with
disassembly. Remove the two brackets (on the right- and left-hand side) that secure the stove to the pallet. To do so, remove the two
screws, slightly lift the stove from the pallet and take out the bracket from the stove's feet.
Install the stove in the chosen area, making sure it complies with the requirements.
The stove body or unit must always be kept in a vertical position when handled, and handled using carts only. Pay particular attention to
the door and its glass, protecting them from mechanical knocks that would compromise their integrity.
The product must always be moved with care. If possible, unwrap the stove near the chosen area of installation. The packaging materials
are neither toxic nor harmful, and therefore no particular disposal measures are required.
Figure 1 - Packaging
Figure 2 - Bracket screws
removal
Figure 3 - Bracket removal