MCZ Flair - Manual (Page 31)

B
f
f
d
d
e
d
29
6-INSTALLATION AND ASSEMBLY
Technical Dept. - All rights reserved - Reproduction is prohibited
• Panel B can be fastened by following the procedures implemented to assemble panel A. The flaps on the lower part of the panel
- pos. d - must enter the holes in the structure, whereas two screws and two nuts on the upper part of the panel, block it to the
structure - pos. f. Panel B rests on the two adjustable screws “e”. Panels A and B could touch or the gap between may be too wide,
therefore, adjust screw “e” to resolve the problem.
SERPENTINE PANELS (INSIDE VIEW)
A = BOTTOM PANEL
B = TOP PANEL
Flaps
B
A