Epson COLOR Copy Station 8600 - Manual (Page 32)

32 Setting Up the Copy Station
c
Caution:
❏
Do not unplug a device when its power is on.
❏ When unplugging a power cord, grasp it by the plug—not
the cord.
Plugging in the printer
1. Check the label on the printer to make sure that the voltage
required by the printer matches that of the electrical outlet it
will be plugged into. Also, make sure that you have the correct
power cord for your power source.
2. Make sure that the printer is turned off. It is off when the
(N) side of the power switch on the left side of the printer is
pushed in.
3. Connect the power cord to the AC inlet on the left side of the
printer.
4. Plug the other end into a properly grounded electrical outlet.