Powerfix Energy-Saving Light - Manual (Page 8)

8 GB/IE
Start-up / Cleaning / Troubleshooting / Disposal / Warranty and Service Safety information / Start-up
Unplug when changing the light bulb.
Unplug from the mains. After opening, live
components can be accessible when plugged
in or switched on.
Have repairs performed by an electrician.
Observe the setup clearance.
1 m
Maintain adequate distance (at
least 1 m) from illuminated surfaces.
The energy saving work light heats
up during use. Keep highly flammable materials
away from the device. Never hang objects
above the energy saving work light, and never
cover.
Never replace the cable yourself. If the cable
of this device becomes damaged, it must be
replaced by the manufacturer, its service centre
or a comparable specialist to prevent hazards.
DANGER: A defective cable must be replaced
by an electrician. This will pose a risk of fatal
injury from electric shock.
DANGER: The product must be disconnect
from the mains before opening the energy
saving work light.
Moderate risk of injury if
disregarded
Do not look directly into the light.
Never look directly into the light. Doing so can
damage the retina.
Allow the energy saving work light to cool down
before touching.
The energy saving work light will be very hot
during and shortly after use and can cause burns
if touched (e.g. when changing light bulbs).
Start-up
Important: This chapter describes the basic
function of the energy saving work light. Carefully
read the chapter to understand and implement the
options and functions.
Observe the following information, particularly the
safety notices, to prevent incorrect operation and
possible defects. If problems occur, please refer to
chapter „Troubleshooting“ or contact our service
address.
The energy saving work light is preassembled.
IMPORTANT: Check all screw fittings before
initial use.
Switching on the lamp
Insert the plug end into the mains socket. The
energy saving work light has two on- and off
switches
13 , 14 for optionally switching on
one, two or all lights. The switches are located
at the back. The symbols on the switch indicate
the respective position as follows:
I = on/ O = off
Inserting / replacing
the light bulb
DANGER: Unplug from the mains before
replacing the light bulb. Risk of electric shock!
Allow the energy saving light
bulb to cool down before touching. Risk of
burns!
1. Open the sight cover
Remove the locking screws 6 at the back of
the device using a cross-tip screwdriver, and
remove the sight cover
8 .
2. Remove the light bulb
Carefully bend the spacer retaining ring 9 up
to remove the light bulb. Unscrew the light bulb
1 from the lampholder, turning counter-clock-
wise.
3. Insert the light bulb
Carefully bend the spacer retaining ring 9 up
and screw the light bulb 1 into the lampholder,
turning clockwise. Then carefully push the
spacer retaining ring
9 down again.
IMPORTANT: Note the light bulb power data.
Only use U-shaped energy saving light bulbs.
4. Close the sight cover
Install the sight cover 8 and screw in locking
screws 6 .
94089_Energiespar-Arbeitsleuchte_content_GB.indd 8 10.12.13 07:19