Elmo PTC-200C - Manual (Page 24)

- 23 -
DIP Switch (4)
8. ALL CLEAR SWITCH
The PAN-TILT settings, the LENS settings, the preset settings, the ID settings and the
Camera settings by means of the OSD can be reset to the factory-settings by turning ON the
switch No. 2 of the DIP Switch (4) on the bottom of the Camera before turning ON the
power supply to the Camera and then turning OFF the same switch after turning ON the
power supply to the Camera.
Note: For all other switches (No. 1, No. 3 and No. 4) of the 4-DIP Switch,
be sure to turn them OFF, or operation via the wireless remote
controller or by other means will not work.
Switch No.
1
2
3
4
Normal
OFF
OFF
OFF
OFF
Operation
None
ON OFF
None
None
Function
N/A
ALL CLEAR
N/A
N/A
Switch assignment