Powerfix Z30590-BS - Manual (Page 10)

10 GB
Preparing for use
j Switch the LED work lamp off during the charging process (put the
on / off switch
4 to position 0).
j Remove the protective rubber pad 5 on the lower side of the LED
work lamp.
j Insert the connection plug of the mains adapter 2 or the connection
plug of the cigarette lighter socket adapter 3 into the connection
socket in the LED work lamp handle.
m ATTEnTIOn! When charging from a cigarette lighter socket, the
adapter must always be fully inserted into the cigarette lighter
socket of the vehicle. Otherwise there is the danger of fire through
overheating.
j Insert the mains adapter 2 into a mains socket or insert the ciga-
rette lighter socket adapter 3 into the cigarette lighter socket in
your vehicle.
note: The product is fitted with an overcharge protection circuit.
In spite of this, you should disconnect the LED work lamp from the
power supply after the charging process is complete.
j The charging indicator lights up red during the charging process.
When the charging process is complete, the charging indicator
lights up green. When the indicator LED work lamp is green, pull
the adapter out of the socket. Also disconnect it from the LED work
lamp so that the batteries do not go flat.
m ATTEnTIOn! Attach the protective rubber pad 5 back onto the
lower side of the LED work lamp before operating it again. Otherwise
water might get onto the connector pin if you use the LED work
lamp outside.