Silvercrest SEC 60 A1 - Manual (Page 24)

22 GB
device to have it completely discon-
nected.
• When you set up the device, ensure
that the power cord is never jammed or
squashed.
• Ensure that children cannot pull the
device on the cable down from the
work surface.
• Always pull on the plug and not on the
cable to disconnect the power plug
from the socket.
• Unplug the power plug from the
socket...
… if there is a malfunction,
… when you do not use the ice crusher,
… before you clean the ice crusher and
… during thunderstorms.
• This device is not intended to be oper-
ated with an external timer or a sepa-
rate telecontrol system.
• Immediately disconnect the power plug
from the socket in the case of damages
to the power cord or the device.
• Do not use the device if it shows visible
damages to the casing or the power
cord. To prevent hazards, do not carry
out any changes to the device. Also, do
not replace the power cord yourself.
Please have repairs only carried out by
an authorised service centre.
• Immediately unplug the power plug in
the event liquids or foreign materials
enter the device. Have the device
checked prior to using it again.
RISK of Injury
• Never reach into the running device
through the filler shaft. Do not insert
any items into the filler shaft. Also hold
long hair or loose clothing away from
the filler shaft. There is a risk of injury
due to the rotating knives of the crush-
ing mill.
WARNING about material damage
• Never place the device on hot surfaces
(e.g. hot plates) or close to heat
sources or open fire.
• Do not exceed the maximum operating
time of 10 minutes since otherwise the
device overheats which creates a fire
hazard.
• Let the device cool down for at least
2 minutes after each operation.
• Do not fill too much ice into the device:
The crushing mill may jam.
• In the case of jamming of the crushing
mill, immediately turn the device off
and wait until the ice in the filler shaft
has melted.
• Only use the original accessories.
• The ice crusher has been designed for
the sole purpose of crushing ice cubes
made of pure water.
• Ice cubes from fruit juices or with col-
our additives may not be crushed since
that can result in the crushing mill
becoming sticky or discoloured. The
ice crusher must never be used for
food of any sort. The leftovers cannot
be removed from the crushing mill.
• The appliance is fitted with non-slip
silicone feet. As furniture is coated with
various varnishes and plastics and
may be treated with different cleaning
products, it cannot be completely ruled
out that some of these substances con-
tain components which may attack and
soften the silicone feet. If necessary,
place an anti-slip mat under the appli-
ance.
• Do not use any aggressive or abrasive
cleaners.
• Clean all the accessories of the ice
crusher by hand. They are not suited
for the dishwasher.
GB_RP_71511_Eiscrusher.fm Seite 22 Montag, 5. Dezember 2011 11:25 11