Silvercrest STGR 1600 A2 - Manual (Page 31)

- 28 -
Installing the Stand
Top plate
Storage plate
Supporting legs
Leg pads
1. Insert the leg pads
on the ends of the legs
where there is not a pre-drilled hole.
2. Assemble the legs
onto the storage plate .
Insert screws through the pre-bored holes and
secure them with nuts from the inner side of the
storage plate
.
3. Place the top plate
on the legs so that the
legs
lie against the pre-bored holes of the top
plate
from inside. The pre-bored holes in the
top plate
as well as those in the legs must
lie opposite each other.
4. Insert screws through the holes and secure them
with the nuts.
Taking it into use
Before taking the table grill into use for the first time
clean it as described in the chapter “Cleaning and
care”.
Usage / grilling may only take place with the catch-
ment pan
r intended for the purpose.
The voltage of the power source must tally with the
details given on the rating plate of the appliance.
Handling the grill
A good and even heat distribution is assured by the
integrated heating element
y under the grill q .
Cleaning is made easier by the non-stick coating,
which prevents the adhesion of grillables.
• Place the assembled stand on a level surface.
Bear in mind that there needs to be a mains power
socket in the close vicinity.
• Fill the catchment pan r up to the max. marking
with water (ca. 1.3 ltrs). You can thus prevent the
burning-on of fats falling from the grillables and
make the subsequent cleaning of the appliance
easier.
• Install the splatter protection shield w on one
side (the later rear side) of the grill bars q should
you be grilling greasy grillables. Additionally, it
serves well as a windbreak. Insert the three te-
nons of the splatter protection shield
w into the
holes provided on one side of the grill bars q .
To do this, the splatter protection shield w must
be lightly flexed.
IB_86020_STGR1600A2_CH 27.11.2012 11:13 Uhr Seite 28