Turning on the remote control, Using the remote control, Stand within about 30 feet of the projector – Epson 8150i User Manual
Page 55

50
Using the Remote Control
Turning On the Remote Control
The remote control has an on/off switch on its side, as shown. Before
using it, make sure batteries are installed (as described in the
Administrator’s Manual), then push up the on/off switch to turn it on.
Turn off the remote control before transporting it or storing it with
the projector in a carrying case; this prevents the batteries from
discharging if something presses against one of the buttons.
Keep the following in mind when using the remote control:
■
Stand within about 30 feet of the projector.
■
Point the remote either at the front or back of the projector or at
the screen (the projector’s front sensor can detect signals bounced
off the screen).
■
When presenting in a darkened room, press the
light button to
make the other buttons on the remote light up temporarily. (This
is also a good way of testing the batteries.)
■
To access additional buttons, pull open the cover as shown:
Power
Freeze
A/V Mute
E-Zoom
R/C ON
OFF
3
1
5
2
4
Enter
Esc
on/off
switch
light
button
pull here to
open cover