Silvercrest SAB 160 A1 - Manual (Page 14)

12
Installation
SAB 160 A1
GB
To avoid function disturbances the installation angle should be less than 30°. ■
Do not install the device in a location where it will be subjected to high ■
temperatures (i. e. direct sunlight or heating vents), heavy contamination and
strong vibrations.
In the event that changes to the vehicle are necessary contact your vehicle ■
dealer/qualifi ed radio installation facility.
Installing the device into the ISO duct
Pull the installation bracket ♦ 48 and the bezel frame 47 from the device’s
housing.
Place the installation bracket into the ISO mounting duct. ♦
Bend the tabs on the installation bracket with a screw driver so that the ♦
bracket is fi xed fi rmly into the mounting duct (see diagram).
Check to make sure that the bracket is securely fi xed. ♦
Connect the ISO socket block of the device with the two ISO plugs on your ♦
vehicle.
Connect the antenna cable from the vehicle antenna to the antenna socket ♦
on the device. The vehicle-specifi c DIN ISO adapter, which under circum-
stances you may need, is available from specialist workshops, specialist
shops or in the specialist sections of department stores.
Feed the microphone unit cable into the aperture and connect it to the ♦
microphone unit socket. Run the cable in such a way that the microphone
unit can be secured in the vehicle interior later, see also the section “Using
the microphone”.
Contingently connect the audio cinch cable of an external amplifi er to the ♦
LINE OUT socket 40 on the device.
Contingently connect the audio cinch cable of an external subwoofer to the ♦
yellow cinch socket SUBWOOFER 38 on the device.