Silvercrest SKF 2300 B2 - Manual (Page 54)

51 SKF 2300 B2
GB
MT
Timer
You can programme in a countdown of up to 60 minutes with the timer q:
1) Press the button “ ” on the Timer q to switch it on.
2) Press the buttons “+” and “-” to set the desired time in minutes.
3) Press on the button “ ” to start the countdown of the time. The programmed
time will blink twice to indicate that the countdown of the time has begun.
Signal tones sound on completion of the countdown.
4) The signal tones will stop when you once again press the button “ ”.
NOTICE
► On expiry of the countdown the heating element 5 is NOT switched off !
Therefore pay heed to the signal tone from the Timer q, so as to avoid
spoiling the food being fried.
► When the battery is depleted, exchange it. Always use a replacement bat-
tery of the same type. Pay heed to the correct polarity when inserting it.
After Frying
1) When the food is ready, pull the handle upwards until the handle locking
button w engages.
2) Leave the frying basket 3 in this position to drip off .
3) Press the On/Off switch 0. The deep fryer is now switched off . Remove the
plug from the mains power socket.
4) When the food has dripped off , open the appliance lid by pressing the lid
release button 6.
WARNING! RISK OF INJURY!
► Never take hold of the frying basket 3 directly after frying. It will be very
hot! Lift the frying basket 3 out of the fryer ONLY by the handle!
5) Carefully lift the frying basket 3 out of the deep fryer. If necessary, shake off
any excess oil or fat over the deep fryer.
6) Tip the fried food into a bowl or a sieve ( lined with absorbent kitchen
paper!).
IB_75818_SKF2300B2_LB5.indb 51 IB_75818_SKF2300B2_LB5.indb 51 27.08.12 11:26 27.08.12 11:26