Emerson Radio ES3 - Manual (Page 20)

19
OPERATING INSTRUCTIONS
• Make sure the Subwoofer and Sound Cylinder Speakers are properly
connected to the main unit.
• Make sure that the Main POWER switch on the back of the Subwoofer is
‘ON’.
• Make sure that the POWER button on the front panel of the Subwoofer is
‘On’. STANDBY LED indicator is ‘Off’.
• Make sure that you have installed the batteries in the remote control,
and the back up batteries in the clock and tuner preset memory battery
compartment.
• Make sure the AC power cords from both the Main Unit and Subwoofer
are properly connected to 120V 60Hz household AC power outlets.
SETTING THE CLOCK
When the main unit is connected to the AC outlet for
the first time the STANDBY LED indicator on the front
panel glows green and “AM 12:00” flashes on the
display. This flashing “12:00” is your indication that
the time display is incorrect and needs to be reset.
Note: Do not turn the main unit power ‘On’. The clock can only be set while the
main unit power is ‘Off’.
1.) Press the MEMORY/CLOCK SET button on the
front panel or the remote control. Just the Hour
digits will continue flashing.
2.) Press the TUNING/SKIP-SEARCH UP or DOWN buttons on the top
panel of the main unit or on the remote control to set the display to the correct
hour, AM or PM.
3.) Press the MEMORY/CLOCK SET button again.
The Minute digits will begin flashing.
ES3_ib032103.p65 21/3/2003, 10:31 19