Silvercrest SDM 800 A1 - Manual (Page 24)

- 22 -
7. After baking the last donut remove the plug
from the power socket and allow the appliance
to cool with the lid open.
Cleaning and care
Important!:
Never open the housing of the appliance. There are
no operating elements inside. When the housing is
open, there is the risk of receiving a fatal electrical
shock. Before cleaning the appliance, ....
• Remove the plug from the power socket and allow
the device to cool down completely.
Under no circumstances may the components
of the appliance be submerged in water or
other liquids! There would be the risk of a fatal
electric shock upon the next use of the appli-
ance should moisture be present in the voltage
conducting elements .
• First of all, clean the baking surfaces with a dry
paper towel to soak up the grease residue.
• Then clean all surfaces and the power cable
with a lightly moistened cloth. Always dry the
appliance well before using it again.
• Do not use detergents or solvents. They could not
only damage the appliance, they can also leave
traces that would be baked into the next donuts.
In the case of stubborn residues:
• NEVER make use of hard objects. These could
damage the coatings of the baking surfaces.
• It is better to lay a wet wash cloth on the encrusted
residues in order to soften them.
Storage
Allow the appliance to cool off completely before
putting it into storage.
Wind the power cable around the cable retainer
w
on the bottom of the appliance.
Store the appliance in a dry location.
IB_62052_SDM800A1_LB5 15.10.2010 11:02 Uhr Seite 22