Silvercrest Energy Monitor - Manual (Page 18)

20 GB
Operation
Q Delete maximum values
j
Use the “UP” button 5 to select one of the two maxi-
mum values (see “Maximum current”, “Maximum power
consumption”).
j
Keep the “SET” button 2 pressed for approx.
3 seconds to set the maximum value to 0.
Q Set the overload warning value
note: in this mode you have a choice between two overload
warning values. You can set an overload warning value for
the current (A) and an overload warning value for the power
consumption (W).
note: the overload warning value for power consumption
(W) 8 is set by default to 0,0 W on delivery.
Proceed as follows:
1. Press the “UP” button 5 until the overload symbol 7
(“OVERLOAD”) appears in the top third of the LC
display 1 .
2. Now press the “SET” button 2 . The ampere symbol 9
starts to flash.
3. Press the “UP” 5 or “DOWN” button 4 to select either
56861_Energiekostenmessgeraet_Content_GB-PL-CZ-SK.indd 20 26.11.10 10:12