Silvercrest SBTF 10 C2 - Manual (Page 17)

GB
14 SBTF 10 C2
Replacing the fuse
The hands-free set is equipped with a fuse. If the device
no longer works, check the fuse and replace if necessary.
Ɣ Open the vehicle connector plug 1 by turning the
fl uted screw insert
A
gently anticlockwise – with pliers
if necessary – and remove it.
Ɣ Remove the plug tip
B
from the fuse
C
and pull the fuse
out. Ensure that the spring
D
in the vehicle connector
plug 1 does not accidentally jump out and become lost.
Ɣ Place a new fuse of type F2AL/250V into the vehicle
connector plug 1, place the plug tip
B
onto the end
of the fuse that is slightly protruding
C
and screw the
screw insert that you removed earlier
A
back in.
Risk of fi re!
Ɣ Replace the fuse only with another of the same rating
as that given on the ratings plate. Fuses with a diff erent
rating may cause fi re. Smoke resulting from such a fi re
is poisonous.
Note:
If these measures do not correct the problem, please con-
tact the appropriate service partner for your country.
D C B A
IB_102629_SBTF10C2_LB4.indb 14 22.05.14 13:20