Silvercrest SBTF 10 C2 - Manual (Page 16)

13 SBTF 10 C2
GB
Charging 5 V Devices
Ɣ Check the max. input voltage (5V) and the max. power
input (1000 mA) of the device which you want to charge.
For this, consult the operating manual of the device.
Ɣ Connect the device to be charged with the USB port 4
on the hands free device. The device now receives its
power supply from the hands free device. If the device
is equipped with a charging indicator light, this will in-
dicate that the device is being charged.
Note:
If the power supply does not activate automatically, you
should disconnect the USB cable from the USB port 4
and re-connect it.
Troubleshooting
If you cannot connect the hands-free appliance with a
compatible mobile telephone, proceed as follows:
Ɣ Ensure that the Bluetooth
®
function in the mobile
telephone is activated.
Ɣ Is the display fl ashing? Ensure that the hands-free ap-
pliance is correctly installed, switched on and supplied
with electricity.
Ɣ If you use several Bluetooth ® appliances, ensure that
a previously created Bluetooth ® connection of the
mobile telephone is separated. This may indicate that
a previously paired device is in range.
Ɣ Ensure that the hands-free appliance is distanced a ma-
ximum of 10 metres from the mobile telephone and that
there are no barriers or electronic devices between them.
IB_102629_SBTF10C2_LB4.indb 13 22.05.14 13:20