Silvercrest SBTF 10 C2 - Manual (Page 12)

9 SBTF 10 C2
GB
Ɣ Position the hands-free appliance and the mobile tele-
phone so that they are not more than 1 metre away
from each other.
Ɣ Press and hold down the multi-function button 6 for 6
seconds until, after 3 seconds a short, high signal tone
and after a further 3 seconds a succession of low and
high signal tones are heard. The LED status indicator
7 lights up constantly and the hands-free equipment is
now in the coupling mode.
Ɣ Select the hands-free provision “Car Kit“ from the list of
available appliances for the mobile telephone.
Ɣ Enter in the pre-programmed passcode “9999“ and
then confi rm it, which couples the appliances with each
other. You will hear a long high signal tone and the
LED status indicator 7 blinks every 3 seconds.
Ɣ You can now use the hands-free appliance.
Note:
When using the latest mobile phones, (Smartphones) those
that are equipped with Bluetooth
® 2.0 or a more mod-
ern version, it is possible that the pass code “9999“ need
not be entered. If the coupling is not completed within 2
minutes, the hands-free appliance switches itself off . The
LED status indicator 7 extinguishes and you will hear a
long and deep signal tone. With some mobile telephones
it is possible that coupling does not automatically take
place. In this case coupling must be carried out addition-
ally on the mobile telephone. The LED status indicator 7
blinks twice every 3 seconds until this has been carried
out. Further information can be found in your mobile
telephone’s operating instructions.
IB_102629_SBTF10C2_LB4.indb 9 22.05.14 13:20