Silvercrest SDG 800 A1 - Manual (Page 50)

52 GB/MT
Safety / Prior to Initial Use / Initial Operation
J Always fill the base of the appliance / water
tank
10 with sufficient water for the period of
steaming. Do not cover the base of the appli-
ance / water tank
10 with aluminium foil or
any other material. If not observed, this can
lead to an overheating of the appliance.
Damage of the appliance is the consequence.
J Never immerse the appliance in water and
always pull the mains plug before cleaning or
transporting it.
J FOOD­SAFE! The taste and smell
of your food are not detrimentally
affected by this product.
Avoid the hazard of
life by electric shock:
J Make sure that the details on the rating label
are in conformity with your mains voltage.
Only connect the unit to alternating current.
J Do not at all operate this unit with an external
timer or a separate telecontrol system.
J Check the power cord 18 regularly
for damage or deterioration.
J Do not operate the appliance when the power
cord
18 or the mains plug is damaged.
AttEntIOn! A damaged power cord 18
presents a hazard of life by electric shock.
Have appliances, which do not work faultlessly
or which are damaged, immediately and only
checked and repaired by the after-sales service.
J Do not use the power cord 18 for unplugging
the appliance. Keep the power cord 18 away
from hot surfaces, sharp edges and mechanical
forces. Damaged or entangled cords
18 in-
crease the risk of an electric shock.
J Do not operate the appliance outside. Never
let the power cord
18 become wet or damp
during operation.
J Unplug the power cord 18 when you are not
operating the appliance.
Q Use Original Accessories
J Only use accessories and additional equipment
stated in the instruction manual. The use of other
products or accessories than recommended
in the instruction manual may present a risk of
injuries for you.
Q Prior to Initial Use
J Clean all detachable parts prior to the initial use
with warm soapy water and dry them carefully.
Wipe the interior of the base of the appliance /
water tank
10 with a damp cloth.
Q Initial Operation
Observe the mains voltage. The mains voltage of
the power source must be in conformity with the
details on the rating label of the appliance. Appli-
ances declared with 230 V can also be operated
with 220 V.
j Place the base of the appliance 10 on a sta-
ble, even surface.
j Then place the black turbo ring 8 onto the
heating element 11 mounted in the centre.
Make sure that the larger side faces down-
wards.
j Now fill the base of the appliance / water tank
10 with cold water up to the MAX mark 19 .
note: Consider that the base of the appliance /
water tank
10 has to be filled with water at
least up to the MIN mark 9 .
AttEntIOn! HAzArD OF BUrnS!
Make sure that the water does not exceed the
MAX mark
19 . Otherwise, hot water may spurt
out of the appliance during operation.
AttEntIOn! Do not add anything like sea-
sonings etc. to the water. This may affect the
steam flow and / or damage the surface of the
base of the appliance / water tank
10 and the
heating element 11 .
j Now place the black condensate collection
basin
7 onto the base of the appliance 10 .
Make sure that the semi-circular elevation
58820_Dampfgarer_Content_LB5.indd 52 11.10.10 16:04