Epson GT-10000 - Manual (Page 5)

EPSON GT-10000+
4 - EPSON GT-10000+ 3/01
Environmental
Temperature: Operating: 41 to 95 °F (5 to 35 °C)
Standby:
− 13 to 140 °F ( − 25 to 60 °C)
Humidity (without
condensation):
Operating: 10 to 80%
Standby: 10 to 85%
Connector pin assignments
Lights and Buttons
The scanner has three indicator lights and two buttons on its
control panel. A
] Start button is located beside the document
table. Light status and button functions are described in the
tables that follow.
Pin number Signal name Function
1 VP Cable power supply
2 VG Cable ground
3 TPB Strobe during receipt, data during
transmission (differential pair)
4 TPB
5 TPA Data during receipt, strobe
during transmission (differential
pair)
6 TPA
READY
light
OPERATE
light
OPERATE button
RESET button
ERROR
light
Scanner indicator lights
Light Light status Color Scanner status
OPERATE On Green Scanner is on.
READY On Green Ready to scan images.
Flashing Scanning in progress.
ERROR On Red An error has occurred.
See Error conditions
table below.
Flashing
Scanner buttons
Button Function
P
OPERATE Turns the scanner on and off.
RESET Initializes the scanner.
]
Start
Automatically launches a
]
Start button-compatible
application. You must set up your scanner software
and a compatible application to use this feature with
any application other than Presto! PageManager.
If you installed Presto! PageManager, it’s
automatically assigned to the
]
Start button. You can
set up Presto! PageManager to scan your image
automatically and send it directly to another application
or a peripheral device, such as a printer.
Error conditions
ERROR light READY light Error type
On On Command error: The scanner has
received incorrect commands from
the scanning software. Try rescanning.
Flashing Off Interface error: Make sure the scanner
is securely connected to the
computer, and then turn the scanner
off and back on again.
Flashing Flashing Fatal error: Make sure the
transportation lock is released, and
then turn the scanner off and back on
again.
Off Off Option error: There’s a problem with
the ADF unit. Make sure the ADF is
flat against the document table. Make
sure it is securely connected to the
ADF connector at the back of the
scanner. Finally, make sure the ADF
isn’t out of paper and doesn’t have a
paper jam.