Epson ACTIONTOWER 7000 - Manual (Page 5)

EPSON ActionPC 7000, ActionTower 7000, Endeavor 486i
System board components
Connector
J1 PS/2 keyboard connector
J3 PS/2 mouse connector
J4 Serial 2 port connector
J5 Serial 1 port connector
J6 Printer (parallel) port connector
J7 15-pin DIN type VGA connector
J9 Power connector
J10 VGA feature connector
J12 Diskette drive connector
J13 Primary IDE connector
J14 Secondary IDE connector
J15 HDD LED connector
J21 Pins 2-3: Turbo LED connector
Pins 9-10: Hardware reset connector
Pins 11-13: Power LED connector
Pins 17-20: Speaker connector
S1 Riser card slot; default settings of PCI AD Select are
AD12 and AD13
U2 AMIKEY-2 keyboard controller
U4, U14, U20, UMC UM82C865, UMC UM8886, CMD PCl0640B,
U21 UMC UM8881 PCI chipset
U 5 SMC FDC 37C665 parallel port super l/O diskette
controller
U 8 Cirrus Logic GD5430 VGA controller
U9, U10 Soldered standard Video RAM
U11 Dallas DS 12887 real-time clock chip
U12 Phoenix system and video BIOS chip
U16, U18 Video DRAM expansion sockets
U22 CPU
U23-27, U35-37 External cache memory sockets
U30 Cache tag RAM chip
SIMM Installation
The computer comes with 4 or 8MB of memory using
SIMMs. By installing additional SIMMs, you can increase the
amount of memory up to 128MB.
There are four SIMM sockets on the main system board, and
each can contain one memory module. You can install 1MB,
2MB, 4MB, 8MB, 16MB, and 32MB SIMMs. The sockets are
labeled on the main system board.
The following table shows the recommended SIMM
configurations. Do not install SIMMs in any other
configuration.
SIMM configurations
5/19/95 ActionPC 7000, ActionTower 7000, Endeavor 486i - 5