Livarno Z30503-BS - Manual (Page 11)

13 GB
Safety Instructions / Preparing for use
during a storm. When doing this, pull directly on the mains adapt-
er
14 / cigarette light socket 13
and not on the lead.
Protect the product against heat, cold, strong vibrations and impacts.
Never point the LED beam on reflective areas, people or
animals. This can blind or irritate people and animals.
Even a LED beam of low power can cause damage to
the eye.
Preparing for use
Charging the rechargeable light batteries
 Do not connect the light to the cigarette lighter socket in your vehicle
if the vehicle battery is very old or exhausted. This could cause the
engine to fail to start.
In order for the device to be used without the mains lead, the
rechargeable batteries must first be charged. The charging process
takes about 8 hours. The rechargeable batteries are permanently
installed in the handle.
You can charge the rechargeable batteries from an ordinary
domestic 230 V ~ mains outlet or from the cigarette lighter socket
in your motor vehicle.
Tip: We recommend charging the light from an ordinary domestic
230 V ~ mains outlet to avoid draining your vehicle’s battery.
Switch off the light during the charging process (press the On / Off
switch
10 , 11 ).
Remove the cap 8 from the connector socket 7 .
Insert the connection plug of the mains adapter 14 or the connection
plug of the cigarette lighter socket adapter 13 into the connection
socket 7 in the light handle.
56632_livx_LED-Arbeitsleuchte_Content_LB4.indd 13 29.12.10 13:18