Livarno 7226 - Manual (Page 7)

7 GB/IE
Safety
J Every time before connecting the lamp the mains,
check it and the mains lead for damage. Never
use your light if you find it is damaged in any way.
CAUTION! A damaged mains lead presents
a serious danger to life from electric shock. In
the event of damage, repairs or other problems
with the lamp please contact the service centre
or an electrician.
J Before installation, remove the fuse for this circuit
or switch off at the circuit breaker (0 setting) in
the fuse box.
J Before assembly, ensure that the mains voltage
available corresponds to the operating voltage
necessary of the light (230 V∼).
J Never let the lamp come into contact with
water or other liquids.
J Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing can
lead to a serious danger to life from electric shock.
J Do not install the lamp on damp or conducting
surfaces.
To avoid danger of
fire and injury
J RISK OF INJURY! Check every bulb and
lampshade for damage immediately upon un-
packing. Do not fit the light if the bulbs and / or
lampshades are faulty. If they are, contact the
service point for a replacement.
J RISK OF INJURY FROM BURNS! Ensure
the lamp has been switched off and allowed to
cool before you touch it. In this way you will
avoid the danger of burns. Bulbs give off a lot
of heat around the top of the lamp.
J Replace any faulty bulbs with new ones imme-
diately. Before replacing the bulb, always re-
move the fuse or switch the automatic cutout off.
J
0.3 m
FIRE HAZARD! Fit the light so that
it is at least 0.3 m away from the
material illuminated.
J DANGER OF EXPLOSION!
Never use the product in rooms or
in the vicinity of easily inflammable
or explosive liquids, gases, vapours or dusts.
J CAUTION! DANGER OF FIRE!
Never cover the downlights with
thermally insulative covers or similar
materials.
J Please ensure there is adequate cooling! The
maximum temperature in the downlight installa-
tion area of 90 °C must not be exceeded.
J Use the downlight set only with the supplied
accessories. Do not interconnect downlight sets.
Failure to observe this advice invalidates your
rights under the warranty.
J Do not allow the lamp or the packaging materi-
als to lie around unattended. Plastic film or bags,
Styrofoam etc. can turn into dangerous toys for
children.
J Do not use cold light lamps with
reflector.
J Not dimmable! The LED lamp
installed is not suitable for dimmers
or electronic switches.
Working safely
J Install the light so that it is protected from mois-
ture, dirt and the build-up of excessive heat. Do
not install the downlights in bathrooms or similar
rooms.
J Use only 230 V∼ bulbs with a GU10 socket
and a maximum power of 5 watts.
J The distance between two installation spotlights
must be at least 20 cm.
J The clearance above and to the sides of the
lamp fitting must be at least 10 cm (see Fig. M).
J Make careful preparations for the assembly
and take sufficient time. Clearly lay out all com-
ponents and any additional tools or materials
that might be required so that they are readily
to hand.
J Remain alert at all times and always watch what
you are doing. Always proceed with caution
and do not assemble the lamp if you cannot
concentrate or feel unwell.