Livarno 7226 - Manual (Page 6)

6 GB/IE
Introduction / Safety
LED Recessed lights
Q Introduction
We congratulate you on the purchase of
your new device. You have chosen a
high quality product. Please read care-
fully and completely through these operating in-
structions. Fold out both pages with the illustrations.
These instructions form part of the product and
contain important information about bringing the
product into use and its handling. Always observe
all the safety advice. Check that the correct mains
voltage is available and that all the parts have
been properly assembled before bringing into use.
Should you have any questions or be uncertain as
to how to operate the device, please get in touch
with your dealer or service point. Please keep these
instructions in a safe place and hand them on to a
third party if necessary.
Q Proper use
This light is suitable only for interior use, in dry and
enclosed spaces. This lamp is intended for use only
in a domestic environment. The light can be fitted to
all normally inflammable surfaces.
Q Included items
Check that all the items and accessories are present
and that the lamp is in perfect condition immediate-
ly after unpacking.
3 Installation spotlights
3 Mains sockets
6 Retaining springs
1 Operating instructions
Q
Description of Parts
1 Lamp housing
2 Bulb
3 Spring ring
4 Retaining spring
5 Cover
6 Terminal block
7 Cable holder
8 Mains socket
9 Fitting
Q Technical Data
Model no.: 7226
Operating voltage: 230 V∼, 50/60 Hz
Bulbs:
230 V∼, 50/60 Hz,
LED GU10, 5 W
Power consumption: 3 x 5 W
Dimensions of
each bulb:
ø 85 mm
Installation opening: ø 68 mm
Protection class:
II /
For the cable harness (not supplied) a minimum
cross-section of 2 x 0.75 mm
2 is to be used. The
corresponding cable is to be provided with wire
end ferrules.
Q Safety
Safety advice
The right to claim under the guarantee shall be ren-
dered invalid in respect of damage caused by the
non-observance of these operating instructions!
No liability is accepted for consequent damage!
No liability is accepted for damage to property or
persons caused by improper handling or non-obser-
vance of the safety advice!
To avoid danger to life
from electric shock
J Ensure that a qualified electrician or a person
trained to carry out electrical installations performs
the electrical installation.