Sealey FH2010 - Manual (Page 2)

 WARNING! Before attempting any maintenance ensure the unit is unplugged from the mains power supply and that it
is cool.
4.1. Clean the heater with a soft dry cloth. DO NOT use abrasives or solvents.
4.2. Periodically check the heater grille to ensure it is not blocked.
NOTE: This heater is fitted with a safety device which will cut the power should the heater overheat. If this happens you
should disconnect the heater from the mains supply for a minimum of 3 minutes allowing the heater to cool,
ensure the heater is not covered or anything is obstructing the vents. Plug the heater back into the electrical
socket and switch the heater back on.
no other maintenance is necessary. If you experience a problem with your heater or if the power lead or plug is damaged
contact your local authorised service agent for repair. DO NOT dismantle or tamper with the heater as this may be
dangerous and will invalidate your warranty.
4. MAINTENANCE
3.1. Position heater where required, either horizontally or
vertically on a level surface ensuring that the air
intake and outlet are not obstructed in any way.
3.2. Plug the heater into the mains supply.
3.3. Set the thermostat knob to the half way position as
shown in fig.1.
3.4. The fan heater will switch on when the selector switch
is set to one of the two power settings (1000W or 2000W).
3.5. once the room reaches the set temperature the
heater will switch on and off automatically to maintain
that temperature. Adjust the position of the thermostat
knob to obtain a comfortable room temperature.
3.6. If the fan fails to operate when a power setting is
selected the thermostatic temperature control may be
set too low. Turn the knob slowly towards max until
the fan starts.
3.7. For a cooling effect turn the selector switch to the fan
only setting.
2. SPECIFICATIONS
Tough composite case with integral carry handle. Can be seated
in a vertical or horizontal position. Two-position heat settings,
control two 1000Watt heating elements. Full range ambient
room thermostat maintains temperature at pre-set level. Fan
doubles as cool air blower for use in the summer. Full CE
approval. Supplied with 13Amp non-rewirable ASTA approved
plug.
Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . FH2010.V2
Voltage:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 230V
Power: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1000/2000W
Dimensions: . . . . . . . . . . . . . . . . . . . . . . . . 230 x 240 x 120mm
Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.2kg
3. OPERATION
fig.1
2000W
mIn
mAX
1000W FAn onlY
lAmP lIGHTS
WHEn HEATER
oPERATInG
THERmoSTATIC
TEmPERATURE ConTRol
noTE: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of
experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible
for their safety. Children should be supervised to ensure that they do not play with the appliance.
Environmental Protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
WEEE Regulations.
Dispose of this product at the end of its working life in compliance
with the EU Directive on Waste Electrical and Electronic Equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. Contact your local solid waste
authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Original Language Version FH2010.V2 Issue: 2(l) - 24/07/14 © Jack Sealey limited