Fig.1 fig.2, Off on on – Sealey CH2800 User Manual
Page 2

3. CERAMIC ELEMENTS
DO NOT touch an element just after switching ‘off’ power supply. Allow to cool.
Ensure that the heating elements are:
• Free of fractures and cracks and are of good general condition.
• Maximum of 1.4kW
WARNING! There are no user serviceable components inside this heater, if an element requires replacing please return to an authorised
Sealey dealer.
2. INTRODUCTION & SPECIFICATION
Powder coated metal construction with two ceramic heating elements pro-
viding instant heat when required. Ideal for workshops and garages.
Features chemically polished reflectors to provide maximum heat emission.
Controllable power output with rocker switches on the side of the unit. Fitted
with sturdy frame and carry handle. Supplied with cable and BS 1363
approved plug.
Min. Power:
1400W
Max. Power:
2800W
Input supply:
230V 13A
Dimensions (W x D x H):
360 x 370 x 555mm
4. OPERATION
GENERAL SAFETY INSTRUCTIONS CONT.
WARNING! Ensure the heater is at least 200cm from any object.
DO NOT leave unattended.
When not in use, store the heater carefully in a safe, dry, childproof location.
Fig.1
Fig.2
Heater Identification Fig.1
1) Heater Element
5) Power on Neon
2) Safety Guard
6) Power On/Off
3) Heater Body
7) Stand
4) Handle
Original Language Version
CH2800.V2 Issue: 2(l) - 12/06/15
4
1
2
6
5
7
3
© Jack Sealey Limited
WARNING! Ensure you read, understand and apply the safety instructions in Section 1 before using the heater.
NOTE! The ceramic element is fragile and therefore it is important that it is not subjected to any unnecessary shocks or vibration and is not
moved when it is on or until cooled down.
4.1
Ensure the heater is at least 2m from any object.
4.2 Plug in the heater and switch it on.
4.3 The heater has the following settings: See (Fig.2).
Position 0:0
Off position.
Position I:0
Upper element only.
Position 0:I
Lower element only.
Position I:I
Both elements.
4.4
When the heater is no longer required, switch off and unplug the unit.
IMPORTANT: DURING RELOCATION, THE HEATER SHOULD REMAIN SWITCHED OFF AND DISCONNECTED FROM THE POWER
SUPPLY.
In the event of the heater being knocked over, a safety cut-out switch, which activates at an angle of 35º ±10º,
will disable the heater.
Follow these steps to re-start the heater.
a)
Switch ‘off’ the heater at the on/off switches. As (Fig.2).
b)
Disconnect the power cord from the power supply.
c)
Return the heater to a standing position.
d)
If no damage has occurred to elements, replace safety guard if applicable, re-connect power cord to the
power supply and switch the heater back on.
Should the power cord require replacement, a complete wiring loom should be purchased and fitted by a
suitably qualified person.
Off
Off
On
On