Sealey RD800 - Manual (Page 2)

5.1. Unwrap the mains lead and plug it into the mains power supply.
5.2. Turn the thermostat control to the highest setting, switch on and the light
will illuminate (fig.3).
5.3. Once the required room temperature has been achieved turn the
thermostat down until the light on the ON/OFF switch goes out. The heater
will then keep the surrounding air at the set temperature by automatically
switching on and off at intervals. You may reset the thermostat at any time.
5.4. Use the switch to turn the heater off and unplug from the mains power
supply. Allow it to cool before handling or storage.
5.5. Safety cut-out. The heater is fitted with a safety tip over switch and a
thermostatic safety cut-out which will automatically turn the heater off
should it be placed in circumstances that cause overheating or malfunction.
Should this happen, switch the heater off and disconnect it from the mains
power supply. Allow the heater to cool before handling. DO NOT use the
heater again until the cause has been identified and remedied. If necessary
return the heater to your Sealey dealer for servicing.
5.6. When used for the first time, set the heater to maximum power for a few
minutes. Ventilate the room well to eliminate the newness smell, typical of
this type of heater.
 WARNING! Disconnect the heater from the mains power, before servicing
or performing any maintenance, which must only be carried out by an
authorised service agent, with the exception of the following.
6.1. Dust the radiator (when cold) with a dry cloth.
6.2. DO NOT use a strong abrasive to clean the radiator.
6.3. When storing the heater in the summer, use the original shipping box and
store in a safe, dry location.
Note: Report any oil leakage immediately to an authorised service agent.
Oil-filled radiator suitable for office, home, showroom and workshop use. Manufactured to rigorous standards and fitted with a safety tip over
switch. Features full thermostatic heat control that cuts power to the heater elements when pre-set temperature is attained. Elements designed
to maximise area of the heated surface in order to transfer more heat to the atmosphere. Fitted with hard wearing feet to allow for maximum
stability.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
email
Environmental Protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
WEEE Regulations.
Dispose of this product at the end of its working life in compliance
with the EU Directive on Waste Electrical and Electronic Equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. Contact your local solid waste
authority for recycling information.
Attach the "snap on" foot (fig.1) onto the opposite outer fin with equal register.
Ensure the radiator stands vertical looking on the end (fig.2) and horizontal when
looking on the side (fig.1).
fig.3
fig.2
fig.1
Original Language Version
RD800 Issue: 1 - 19/05/14 © Jack Sealey Limited
 WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that
may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into
this product, but must be applied by the operator.
NOTE: This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or
lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a
person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
2. INTRODUCTION
4. ASSEMBLY
3. SPECIFICATION
Model No: . . . . . . . . . . . . . . . . . . . .RD800
Power:. . . . . . . . . . . . . . . . . . . . . . . . 800W
Supply:.. . . . . . . . . . . . . . . . . . . . . . . . 230V
Weight:. . . . . . . . . . . . . . . . . . . . . . . .3.1kg
Size (WxDxH): 280mm x 100mm x 390mm
Timer: . . . . . . . . . . . . . . . . . . . . . . . . . . . No
Safety Tip Over Switch: . . . . . . . . . . . . Yes
5. OPERATION
6. MAINTENANCE
Snap on foot
Thermostat
ON/OFF Switch
(illuminates when switched on and
whilst heating, extinguishes when
required temperature is reached)