Sealey LP14 - Manual (Page 3)

Environmental Protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
01284 757500
01284 703534 [email protected]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Original Language Version © Jack Sealey Limited
LP14.V2 ISSuE : 3(I) 04/05/15
7.1. Storage
7.1.1. Disconnect the cylinder and store it in a well ventilated area away from combustable material, preferably in an outhouse.
7.1.2. The heater should be covered in a dry, dust free cover and placed in its original packaging.
7.2. Cleaning
7.2.1. DO NOT clean the heater when it has just been turned off.
7.2.2. use a soft, dry cloth.
7.2.3. DO NOT clean with aggressive, abrasive or inflammable substances, they could cause a fire or damage the paint.
7.3.. Maintenance
7.3.1. Any repairs must be performed by specialised personnel and using original replacement parts.
7.3.2. To ensure proper operation of the burner, we recommend annual maintenance, performed at an authorised service centre.
7.3.3. DO NOT make any modifications to the heater, it is dangerous!
NOTE: Spiders or small insects could take up residence inside the burner or nozzle altering the flow of gas and combustion. Inspect
them frequently.
fig.3
7. MAINTENANCE
FAULT POSSIBLE CAUSE REMEDY
Gas leak Regulator and hose connection.
Valve and hose connection.
Split or perished hose
PoL nut connection
Brush a solution of washing up liquid and water
on to all connections and look for active
bubbles. Tighten clips or replace hose.
Check PoL nut fitting is tight (ACW)
Inefficient combustion across the ceramic
plaque.
Missing piece of creamic fire clay.
Gas jet holes blocked.
Replace plaque or repair with a compatible
fire cement and leave to set for
approximately 48 hours.
Clear blockages
Burner flame extinguishes during operation. Low gas or empty bottle.
Thermal element not hot enough.
The wind has extinguished the flame.
Thermal element faulty.
Faulty manual valve.
Change the gas bottle.
Go through the start up procedure again.
Allow to cool before restarting. Move
appliance away from draughts.
Replace the thermocouple. Contact your
Sealey Dealer.
Replace the valve. Contact your Sealey
Dealer.
Heater will not light. Gas cylinder valve is closed
Volume control not opened fully when
atempting ignition.
Insects inside the burner
Turn on the gas cylinder control, check for
leaks.
Read instructions 6.1.2, 6.1.3 and 6.1.4 for
ignition process.
Clear blockages.
8. TROUBLESHOOTING