Electrolux EFC70011 User Manual

Page 20

20 electrolux

INSTALLING THE COOKER HOOD

Fitting the Wall Brackets

• Draw a vertical line on the supporting

wall up to the ceiling, or as high as
practical, at the centre of the area in
which the hood will be installed.

• Draw a horizontal line at 650 mm

above the hob for installation without
the back panel, or at height H
(H=height of the visible part of the
panel) for installation with the back
panel.

• Place bracket 7.2.1 on the wall as

shown about 1-2 mm from the ceiling
or upper limit aligning the centre
(notch) with the vertical reference line.

• Mark the wall at the centres of the

holes in the bracket.

• Place bracket 7.2.1 on the wall as

shown at X mm below the fi rst bracket
(X = height of the upper chimney
section supplied), aligning the centre
(notch) with the vertical line.

• Mark the wall at the centres of the

holes in the bracket.

• Place bracket 7.1 as shown 95

mm from the vertical reference line
and 210 mm above the horizontal
reference line.

• Mark the centres of the holes in the

bracket.

• Repeat this operation on the other

side.

1÷2

650 min.

7.2.1

7.1

210