Epson STYLUS 7890 - Manual (Page 165)

165
Maintaining and Transporting the Printer | 165
Cleaning the Printer
To keep your printer working at its best, clean it if it becomes soiled.
1. If your prints are soiled by ink on the roller, load inexpensive roll paper
and press d to feed the paper without printing on it. Press d several
times until the paper is clean.
2. Turn off the printer and wait until all the lights are off. Then unplug the
power cord and disconnect the printer from your system.
3. Open the front cover and use canned air or a soft lint-free cloth to
carefully clean away any dust or dirt inside the printer.
4. Clean the area shown below in the direction of the arrows. If necessary,
dampen the cloth, clean the inside of the printer, then dry it with a soft
cloth.
Caution: Be careful not
to touch the gears inside
the printer.
To avoid damaging the
components as well as
the case, never use
alcohol or thinners to
clean the printer.
Be careful not to get
water on the printer
mechanism or electronic
components.
Don’t use a hard or
abrasive brush.
Don’t spray the inside
of the printer with
lubricants; unsuitable
oils can damage the
mechanism. Contact
Epson if you think the
printer needs lubrication.
Do not touch the gray
area, roller, or absorption
pads inside the printer;
otherwise your prints may
be soiled.