beautypg.com

Loading paper manually, Using continuous paper with optional push tractor, Installing the push tractor – Epson 3250 User Manual

Page 6: Actionprinter 3250

background image

ActionPrinter 3250

l

When you want to push the paper support

back into the paper

cassette, first remove paper from the paper cassette. Then push

Using Continuous Paper with Optional Push Tractor

the paper support in while pushing

down on the locking tab.

You can use the

Optional

push tractor to print on continuous paper

from 101 mm (4 inches) to 254 mm (10 inches) wide.

l

The default page length for the paper cassette is 65 lines

(A4-size

paper) or 61 lines (letter-size paper). You can change it using
your application software or printer commands, if necessary.

l

You can switch to manual insertion or to the optional push

tractor without removing the paper cassette.

Loading paper manually

You can load single sheets of paper from the rear manual insertion
slot. (If you’ve installed the optional push tractor, remove it before

loading paper manually.)

1. Place the printer in the upright position and turn it on.

2. Next, lower the flap on the rear slot. Then insert a single sheet

into the slot, aligning the paper edge with the arrow mark on the
printer case. The page loads automatically. When the printer
receives data, it begins printing.

Be sure to raise the flap when not using manual insertion.

CAUTION:

Be sure to turn on the printer

before you insert

the page into the slot. If you turn on the printer

after

paper insertion, the printer prints on the platen without
loading the paper.

l

You can adjust the top-of-form position in the same way

that

you do for paper loaded from the cassette.

l

When you want to switch to the paper cassette, press the

FORM

FEED button without inserting a page into the rear slot. The
printer loads a page from the cassette.

Installing the push tractor

1.

Make sure the printer is turned off and is in the flat position.
Remove the paper guide.

2.

Make sure the paper-release lever is lowered to the single-sheet
position.

3. Hold the tractor as shown and fit the edges of both sides into the

slots at the back of the printer. Then lift it straight up until you
hear the unit snap into place.

4. Raise the paper-release lever to the continuous-paper position.

AP-3250-6

3/17/92

24-Pin Printers