beautypg.com

Electrolux EKC6046 User Manual

Page 36

background image

36

FITTING INTO THE CABINET


IMPORTANT: Ensure that the oven is

switched off at the wall before any further

work is carried out.

Using a tape measure establish the internal width

of the cabinet. Refer to page 29 if greater than

565mm.

Position the appliance in front of the cabinet. See

Fig. 8.

Take out all oven furniture before installation to

reduce the weight you need to lift. The oven door

should be taped up to keep it closed whilst lifting.

To place the appliance into the cabinetry follow the

procedure below:

N.B. Two people will be required to carry out the

lifting procedure.

Warning: Do not attempt to lift this appliance

by the handle(s).

a) Each person should squat either side of the

appliance.

b) Tilt the appliance so that your hands can support

the underside of the appliance.

c) Keeping your back straight, raise the appliance to

the correct height by straightening at the knees.

d) Rest the rear underside of the appliance on the

cabinet floor while your hands support the front.

e) The appliance can be pushed fully into the cabinet.

Take care to avoid fouling the mains lead.

f) Ensure the appliance is central and level.
g)

Do not remove spacers fitted behind fixing holes.

h) When the appliance is fully housed screw the

stability screws (supplied with the appliance) into

the side of the cabinet taking care not to distort

the side trims (See Fig 9). It is advisable to turn

each screw alternatively to avoid damaging the

trims.

i) Switch on the appliance then refer to the operating

instructions.

Fig. 9

Fixing points for

stability screws

Fig. 8