Electrolux EKC6046 - Manual (Page 31)

31
INSTALLATION INSTRUCTIONS
WARNINGS
•
This appliance must be installed by a qualified
electrician/competent person. Safety may be
impaired if installation is not carried out in
accordance with these instructions.
•
This appliance must be earthed.
•
Do not remove the screws from the earth tab
extending from the oven mains terminal block
(Fig. 1).
•
Before connecting the appliance make sure that
the voltage of your electricity supply is the same
as that indicated on the rating plate. This is
situated on the lower front frame of the appliance
and can be seen upon opening the door.
Alternatively the rating plate may also be found on
the back or top of some models (where
applicable).
•
Do not alter the electrical circuitry of this
appliance.
THINGS TO NOTE
•
This appliance is designed to be fitted in cabinets
of the recommended dimensions as shown (Fig.3).
•
If your cabinet interior dimension is between 565-
570mm the oven may still be fitted. However, a
minor modification to the cabinet will be required
to reduce the aperture size down to 560-565 mm,
to allow the product to be securely screwed into
the cabinet.
•
The dimensions given provide adequate air
circulation around the unit within the cabinet,
ensuring compliance with BS EN60-335.
•
Enquiries regarding the installation of the cooker
point, if required, should be made to your Regional
Electricity Company to ensure compliance with
their regulations.
•
The appliance socket switch should be outside the
cabinet but within 2m of the appliance to make it
accessible to switch off the appliance in case of an
emergency.
•
To protect the hands, wear gloves when lifting the
oven into its housing.
Do not lift the appliance by the handles.
NOTE: HOUSE CIRCUIT
Earth leakage and continuity tests must be carried out
before the appliance is connected to the mains supply
and re-checked after fitting.
Fig.1