Hepa cartridge filters, How to clear hose clogs, Filters in filter frame – Eureka 4390 Series User Manual
Page 9
9
To remove HEPA cartridge filters
1. Push down latch and pull filter cassette back.
2. Then lift filter up and remove.
To replace HEPA cartridge filters
1. Place bottom tabs of filter cassette into slots.
2. Rotate filter toward cleaner.
3. Push upward on the latch to secure into
place.
NOTE: To have the benefit of a sealed
HEPA system, you must use
one of the HEPA cartridge filter
systems.
HEPA Cartridge Filters
(Only for models with HEPA cartridge.)
Check the HEPA filters with each disposable dust bag
change. Replace twice a year or after every six bag
changes.
Latch
Tabs
Filter Cartridge
(One complete
unit)
How to Clear Hose Clogs
Note: Turn off the switch and unplug the
electrical cord before clearing hose.
1. Step on handle release.
2. Lower handle until cleaner is flat on the floor.
3. Turn the cleaner over so back side faces up.
4. Lift cleaner and rest it against a support or
counter.
5. Pull upward on the attached wand portion of the hose
assembly and remove from the hose retainer.
6. Check for clogs in the hose retainer and throughout
the hose assembly.
7. Use a tool that will not puncture the hose. Clear any
debris from the hose retainer or the hose assembly
that could restrict the air movement.
8. Flexing the hose may help loosen the clog.
9. After the clog is removed make sure the hose
assembly, and handle are reassembled onto the
unit.
10. If the clog is hard to remove, check the brush roll
area. Remove the hood and clear the hose inlet in
the brush roll area.
To remove filters from filter frame.
1. Push down latch and pull filter frame back.
2. Then lift filter up and out of filter frame.
To replace filters into filter frame.
1. Place new filter in filter frame. Place bottom tabs of filter frame
into slots.
2. Rotate filter frame toward cleaner.
3. Push upward on the latch to secure into place.
Use GENUINE EUREKA replacement filters, HEPA ,
part no. 61500; Micron, part no. 60801.
Filters in Filter Frame
(Only for models with filter frame)
Check the filter each time dust cup is emptied or as needed.
Replace twice a year as needed.
Filter Frame plus
filter (depending
on your vacuum
model)
Filter
Filter
Frame
Hose
Assembly
Attached
Wand
Hose
Retainer