beautypg.com

How to assemble, General information, Service information – Eureka 4390 Series User Manual

Page 3: Thermal cut off, Step a attach hose

background image

HOW TO ASSEMBLE

CAUTION: Assemble the cleaner before using.

CAUTION: Moving parts, make sure on/off switch

is in off position before plugging in.

NOTE: Features may vary by model yet all parts

assemble the same.

Step A Attach Hose

To reduce the risk of electric shock, this appliance has a polarized plug (one blade wider than the other). This plug will fit

in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a

qualified electrician to install the proper outlet. Do not change the plug in any way.

GENERAL INFORMATION

The cleaner is designed to pick up dirt and dust particles. Avoid picking up hard or sharp objects with the cleaner to prevent

bag tears, hose clogs, and fan blade breakage with subsequent motor damage.

Service Information

The instructions in this booklet serve as a guide to routine maintenance. For additional service information telephone our toll

free number for the nearest Eureka Authorized Warranty Station. You should know the model, type and serial numbers

when you call:

.

USA: 1-800-282-2886

Mexico: 5670-6169

Canada: 1-800-282-2886

If you prefer, you can write to:

The Eureka Company, Service Division, 807 North Main Street, Bloomington, Illinois 61701, USA.

In Canada write to The Eureka Company, 866 Langs Drive, Cambridge, Ontario N3N 2N7.

Refer to The Eureka Limited Warranty for complete service information.

DO NOT OIL the motor or the brush roll at any time. The bearings are permanently lubricated and sealed.

3

Thermal Cut Off

This vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenly

shuts off, push the switch pedal once and unplug the cleaner. Check the cleaner for a possible source of overheating such

as a full bag, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes before

attempting to use the cleaner. After the 30 minute period, plug the cleaner back in and turn on the switch. If the cleaner still

does not run, then take it to a Eureka Authorized Service Center for repair.

Tab

Hose

Adapter

1. Locate the tab on the hose

adapter of the extension hose

(shortest end).

2. Insert hose adapter into

opening on top of unit. The

hose adapter tab must be

placed all the way down

into the notch.

IMPORTANT:

Hose

MUST BE

inserted

before attaching

the handle.

Notch

2

1

This manual is related to the following products: