Elmo Micro Video Camera System SUV-CAM - Manual (Page 7)

Introduction (Continued)
87
BEFORE YOU USE
Temperature of the main body
When this recorder is used for a long time in the power-on state, the temperature of the main body may become high. However, this
is not a fault.
„ The power plug cord applicable to the local power specifications is attached. Be sure to use power cord applicable to your local
power specification.
„ Use only the attached AC adapter. Do not use any other AC adapter on any account.
„ Use this recorder under the following environmental conditions:
Temperature: 0°C to 40°C (32°F to 104°F) Camera Head: -10°C to 50°C (14°F to 122°F)
Humidity: -10 to 80% (No condensation)
„ Do not place this recorder at any of the following places:
*
A place exposed to direct sunlight, a humid or dusty place, a place exposed to sea wind
* A place with an extreme temperature or humidity variation, such as near an air conditioner
* A place near magnet or magnetic field
„ Camera head
If the camera head has been used in water, such as sea and river, wash the camera head completely with fresh water, wipe the water
off the camera head with a dry, soft cloth, and dry the camera head completely in an airy, shaded place.
„ Note: The recorder and the AC adapter are not waterproof.
„ Camera cable
*
Note: Pulling or dragging the camera cable when using the camera could cause failure to the recorder or the camera.
* Note: If there is a break or hole in the camera cable coating this could cause water penetration through such break or hole and
resultant failure in the recorder or the camera.
„ Do not clean the recorder with volatile solvent, such as thinner and benzene; this could cause the recorder to fail. Clean this
recorder only with a dry, soft cloth.
„ Do not rub or hit the front or the LCD panel roughly, the front or the LCD panel could be damaged or broken.
„ Do not point the camera lens directly at the sun, or the camera may malfunction.