Electrolux Wave-Touch 137018100 A - Manual (Page 26)

26 Operating User Interface Features
Setting Preferences, con’t
INSTALL CYCLE
Run the INSTALL CYCLE before operating the
dryer the first time. Remove all items from the
dryer drum and press
start. For more information
on performing the dryer INSTALL CYCLE, refer to
the Installation Instructions accompanying this
dryer.
If the dryer has been installed according to In-
stallation Instructions, INSTALL PASS! will be
displayed and the dryer is ready to use.
If the dryer was not installed properly, SERVICE
CORD , NO GAS or CALL SERVICE 877 435
3287 will be displayed to indicate the installation
error.
The errors may result from the following condi-
tions:
SERVICE CORD • (electric dryer)—The power
supply cord has been installed improperly or the
house wiring to the receptacle is incorrect.
NO GAS • (gas dryer)—There is no connection
between the dryer and the gas line or the valve
is closed.
CALL SERVICE • —Error can only be corrected by
calling a qualified technician (1-877-435-3287).
Repeat the INSTALL CYCLE when corrections are
completed.
NOTE
The INSTALL CYCLE is prompted automatically
only once when the dryer is turned on the first
time at the end of installation. After that, if you
wish to run a subsequent
INSTALL CYCLE when
moving the dryer or modifying your installation,
you may perform your own
INSTALL CYCLE
by selecting it in the set prefs feature and then
following the screen prompts.