Electrolux OHV User Manual

Page 32

Section 7.18: Replace Speed Control Linkage or

Speed Control Assembly

1) Check for proper linkage adjustment in

Section 6.24 before replacing part.

2) Remove control panel (see section 7.11 )

Section 7.19: Remove and Replace Power

Steering Control Cable

1) Remove fuel from fuel tank
2) Position blower auger end down.
3) Remove klik pin that secures wheel,
4) Remove wheel

4) Remove the two 5/16" hex head screws

holding control to handle assembly.

5) Reverse process to install a new linkage

and perform adjustment in Section 6.24.

3) Remove retainer spring from both ends of

linkage.

9) Remove 5/16" screw that secures trigger to

handle.

10)Reverse process to install cable.

7) Remove spring and pin holding bellcrank.
8) Unhook cable from bellcrank. Remove

5/16" screw that secures trigger to handle.
Remove cable.

5) Remove hardware that secures the power

steering cover.

6) Cut wire ties that secure power steering

cable to handle, noting location of ties.

SCREWS

SPEED CONTROL
ASSEMBLY

POWER STEERING COVER

NUT &
WASHER

RETAINER
SPRINGS

BELLCRANK

PIN

CABLE

TURN TRIGGER

5/6" HEX HEAD
SCREW

5/16" SCREWS

For Husqvarna Parts Call 606-678-9623 or 606-561-4983