Crivit WH-2097 - Manual (Page 5)

5 GB/IE
safety instructions
caution!
There is a risk of tipping, drifting or drowning if
these instructions are not followed. Uneven distri-
bution of load on the article will cause tipping.
Warning!
Risk of suffocation for children! Do not allow
children to play with the packaging material or
the product without supervision.
Warning! mortal danger!
Will not protect against drowning!
For swimmers only!
caution!
The air chambers can be pushed below the
water surface during ascending.
Due to this reason and as well as due to single-
sided loading the product can tilt.
risk of injury!
• Use the device only for its intended purpose.
• The product may only be used by persons
who are familiar with the safety information.
• Please take note of the maximum highest
load. Exceeding the weight limit can lead
to product damages as well as influence the
functions negatively.
• Check the product for damages or wear
before each use. The product may only be
used while in good order and condition!
Do not use the product if visual damages can
be seen or are suspected.
• Do not use the product anymore if it can no
longer constrain air.
avoiding damage to the product!
• All inflatable products are sensitive to the
cold. The product should thus never be un-
folded and inflated at temperatures below
15° C!
• If air pressure increases in direct sunlight, it
should be adjusted correspondingly by re-
leasing some of the air.
• Please ensure that the product – particularly
when it is inflated – is not brought into contact
with stones, gravel or sharp objects and that it
does not chafe or rub against anything, as
damages to the foil could otherwise occur.
• Only insert suitable pump adapters into the
safety valves. Otherwise the valves could
become damaged.
• Do not inflate too strongly, as this could cause
the welded seams to burst open. Seal the
valves tightly after inflating.
• Avoid contact with sharp, hot, pointed or
dangerous objects.
inflating
attention!
• all air chambers must always be com-
pletely inflated!
• avoid excessively inflating the air
chambers as this could cause the
welded seams to overstretch or even
burst open.
• use standard foot pumps or double-
action hand pumps with the correct
adapters to inflate the product.
• do not inflate the product with com-
pressors or compressed air bottles.
this could damage the product.
• make sure that the chambers are
equally filled with air one after the
other.
• only inflate the chambers enough
such that they are still slightly wavy
on the inside after being inflated.
pump up the air chambers in the follow-
ing order (figure a):
1 – Head section (1)
2 – Bed section (2)
1. Open the valve closure (1) (figure B).
2. Inflate the air chambers.
3. Close the valve closure and push in the valve
with light pressure.
empty the air
1. Pull the valve out.
2. Pinch the valve shaft (2) (figure B) lightly
together so that the air can escape.