Electrolux U02108 EOD 982 - Manual (Page 15)

Please note that this is a 24 hour clock, for example
2.00 pm is shown as 1400.
In the following pages we explain how to set the
controls. Read through them a few times until you are
familiar with the procedure.
If the oven is switched off on the wall, or there is a loss
of power, the clock will stop and you will not be able to
use the main oven. When you first switch the electricity
supply on, the timer display will flash.
TO SET THE TIME OF DAY
Turn the selector knob to 'Manual' then turn to 'Time
Setting'.
Set the correct time by turning and holding the setting
knob clockwise. Adjust the time by turning the setting
knob in either direction.
Turn the selector knob back to 'Manual'.
TO USE THE COUNTDOWN
Turn the selector knob to 'Countdown'. Turn the setting
knob clockwise until the display shows the time you
want. The bell symbol ( ) will be showing and this
will stay lit up during the time. Our diagram shows the
timer set to 5 minutes.
If you change your mind and want to cancel the time
you have set, simply turn the setting knob anticlockwise.
Then turn the selector to 'Manual'.
When you are using the 'Countdown' you can make the
clock show the time of day by turning the selector knob
to 'Manual'. The bell symbol will stay on to remind you
that the 'Countdown' is set. At the end of the timed
period an alarm will sound and the bell symbol will go
out.
Switch off the alarm by turning the selector knob to
'Time Setting'. Then turn to 'Manual' and the time of day
will show in the display.
Note:
You can use the minute minder when an automatic
sequence has been set, as long as you remember the
following point.
1
Turn the selector knob to 'Automatic' as soon as you
have entered the timed period into the display.
THE OVEN TIMER
Selector Setting knob
Cookpot symbol Bell symbol
15