Crivit KI-1740 - Manual (Page 12)

12 GB
removing the skates
Prepare the skates for wear
following delivery
important!
ensure that your inline skates fit
correctly. the outer boot should not
become deformed when you close the
quick-release fastener. Do not use force
to close the quick-release fastener.
if your outer boot is deformed then this
is either a sign that the tension is incor-
rect or that you may have purchased
inline skates in the wrong size.
note!
to find the right tension for your foot,
pull the rocker fastener upwards at an
angle and move the ratchet strip to the
correct position for you.
1. Push the pressure slide (3) on the quick-
release fastener (4) inwards in the direction
of the arrow, and open the quick-release
fastener (figure G).
2. Pull the rocker fastener (2) upwards at an
angle, and pull the ratcheted strip (1) out of
the opening on the rocker fastener
(figure H).
3. Open the Velcro fastener (5) (figure I).
4. Open the laces (6).
Putting the skates on
1. Pull on the inline skates using the donning
aids (7) (figure J).
2. Do up the laces.
3. Close the Velcro fastener.
4. Push the ratcheted strip into the correct
opening under the rocker lock, and set it to
the correct tightness (figure K).
5. Close the quick-release fastener (‘CLICK’).
Maintenance
Changing the brake (figure l)
note:
Worn brakes do not function correctly.
an angle of more than 40 degrees
between the frame and the surface is
a sign of worn brakes. if the distance
between the brake block and the
ground becomes too large (more than
17mm), then the brake block must be
exchanged.
• Unscrew the brake block (3) on the inline
skate with the enclosed Allen key.
• Pull the brake block screws out and remove
the brake block (1) from the brake block
mounting (2).
• Attach the new brake block back onto the
brake block mounting securely using the
brake block screws.
Changing the rollers (figure M)
important!
• Please observe the chapter on
technical data:
rollers with a different diameter
could change the handling
characteristics and could mean a risk
to the user in some circumstances.
You should therefore not use the
skates if the rollers cannot be fitted
perfectly. never install larger rollers
then those originally used in the
inline skates.
• Please observe the following with
regard to the axle bolts:
self-sealing lacquer must be re-
applied to the screw thread after the
screw connection has been released.
We recommend always doing this
step as a precautionary measure.
self-sealing lacquer is available from
DiY stores or specialist retailers.