Electrolux EWN 14991 W - Manual (Page 44)

44 electrolux installation
Note
Please ensure that when the appliance
is installed it is easily accessible for the
engineer in the event of a breakdown.
In the interest of the environment
Washing machines and dishwashers
should be connected to the FOUL
drainage system, the water will then be
taken to a sewage works for treatment
before being discharged safely into a
river.
It is essential that these appliances are
not connected to the surface water
drainage system as this water is
discharged directly into a river or stream
and may cause pollution.
If you require any further advice please
contact your local water authority.
SHOWER
BATH
SINK TOILET
BIDET
WASHING
MACHINE DISHWASHER
RAINWATER
'RUN-OFF'
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER
FOUL DRAIN
FOUL SEWERS
SEWAGE
TREATMENT
WORKS
RIVER
P0987
TREATED
DISCHARGE
Electrical connection
Any electrical work required to install
this appliance should be carried out by
a qualified electrician or competent
person.
Important!
This appliance must be earthed.
The manufacturer declines any
liability should this safety measure
not be observed.
Before switching on, make sure the
electricity supply voltage is the same
as that indicated on the appliance’s
rating plate.
Important!
Information on the electrical
connection is given on the rating
plate on the inner edge of the
appliance door.
The appliance is supplied with a
13amp plug fitted. In the event of
having to change the fuse in the plug
supplied, a 13amp ASTA approved
(BS1363/A) fuse must be used.
Should the plug need to be replaced
for any reason, proceed as described
below.
The wires in the mains lead are
coloured in accordance with the
following code:
Green and Yellow ....................-Earth
Blue ........................................-Neutral
Brown......................................- Live
132972250 EN.qxd 13/04/2007 14.22 Pagina 44