Crivit SP - 56 User Manual

Page 8

• If the chin strap (Fig. G.3) is too loose it must be pulled tight using the winding (Fig.

G.2) on the fastener (Fig. G.1).

• If the chin strap (Fig. G.3) is too tight it must be loosened also using the winding (Fig.

G.2) on the fastener (Fig. G.1).

please note that you must always make sure that the fastener is
closed before you ride !!! (Fig. F)

Please be aware that the helmet can only protect if it fits properly.
please try out different sizes and choose the one in which the helmet
fits comfortably and sits firmly upon your head.

5. Visor

• Carefully pull out the pins on the visor from the pin holes on the helmet shell to remo-

ve the visor (Fig. H).

attention: the pin holes on the helmet can expand through excessive
use. in this case, the visor may no longer be used.

6. Cleaning and care

• All chemicals, paints and stickers can seriously impair the protective effect of the

helmet.

• Only clean your helmet with lukewarm water, mild soap and a soft cloth.
• After every use, leave your helmet exposed to the air in order for it to dry.

7. disposal

Please contact your local waste disposal company for the disposal of the helmet.

Bicycle helmet SP - 56

• The helmet should be checked for visible deficiencies at regular intervals.
• The helmet must be replaced after every hard knock, impact or deep scratch, because

these cause it to lose its protective effect.

• Any adjustment to or removal of the original parts of the helmet can extremely impair

its protective function. The helmet may not be altered in order to make additions in a

way not recommended by the manufacturer.

• Clean the inner padding with lukewarm water and mild soap and then let it air dry
• High temperatures, from as low as 60° C, can seriously damage the helmet. Uneven

helmet surfaces and the formation of small blisters are signs of such damage. Do not

store behind panes of glass, e.g. in the car or close to sources of heat or warmth.

User information
1. the correct helmet position

• The helmet must always be levelly horizontal on your head.(Fig. A)
• If the helmet is too far forward, it can impair your vision.
• If the helmet is too far back, your forehead is not sufficiently protected. (Fig. B)

2. adjusting the single-hand twisting fastener

The integrated size-adjusting system can be adjusted using a turning knob at the back of

one’s head (Fig. C):

• smaller = twist clockwise
• bigger = twist anti-clockwise

3. adjusting the strap divider

• Open the strap divider (Fig. D)
• The strap divider must be positioned in such a way, that the straps are taut but comfor-

table. The strap divider must be below the ear, and the straps must not cover the ears.

• Close the strap divider (Fig. E)

an open strap divider can lead to slipping of the helmet in the event
of an accident and thus to a loss of protection!!!

4. adjusting the chin strap

• The chin strap (Fig. G.3) has been adjusted correctly if you feel slight pressure when

you open your mouth.