Electrolux PL36WC50EC - Manual (Page 7)

- 8 -
PREPARE THE HOOD
(NON - DUCTED HOODS ONLY)
Note: The following materials must be purchased separately for non-ducted recirculation installations.
• Non - Ducted Recirculation Kit, Model DFKTWC50EC.
• 5” diameter metal duct.
1. Discard discharge collar supplied with the hood. Install the 5” to 6” adapter supplied with the Non-Ducted Recirculation
Kit. Fig. 10.
2. Secure the plenum to the flue mounting bracket with (2) 3.9x6mm flat head screws (the screws are supplied with the
Non-Ducted Recirculation Kit). Fig.11.
INSTALL THE HOOD
Note: at least two people will be required to mount the hood.
1. Raise the hood into its mounting position.
2. Align the rectangular opening on the back of the hood with the wall-mounting bracket. Gently lower the hood until it
securely engages the bracket. Fig. 12.
3. Level the hood with (2) mounting screws (3.9x9.5mm) and secure with (4) mounting screws. Use drywall anchors
provided if wall studs or framing are not available. Fig. 12.
4. On ducted hoods, attach 6” round metal duct between the hood’s blower collar and duct that leads to the outside location.
5. On non-ducted hoods, attach 5” round metal duct between the 5”-6” adapter on the hood and the connector on the
plenum.
6. Tape all duct joints to make them secure and air tight.
FIG.12
MOUNTING SCREWS
(4.8x38mm)
RECTANGULAR
CUTOUT
WALL FRAMING
MOUNTING
BRACKET
MOUNTING SCREWS
(4.8x38mm)
FIG.10 FIG.11
5”-6”
ADAPTER 3.9x6mm
FLAT HEAD
SCREWS
PLENUM
FLUE MOUNTING
BRACKET
MOUNTING SCREWS
(3.9x9.5mm)
DRYWALL
ANCHORS