Prepare the hood, Install flue mounting bracket – Electrolux PL36WC50EC User Manual

Page 6

- 7 -

PREPARE THE HOOD

Note: On stainless steel hoods, carefully remove the plastic protective film

from all exterior surfaces of the hood and decorative flues, prior to final

installation.

(DUCTED HOODS ONLY)

Install the discharge collar into the duct connector of the range hood. Fig. 9.

DISCHARGE

COLLAR

DUCT

CONNECTOR

FIG. 9

INSTALL FLUE MOUNTING BRACKET

(DUCTED AND NON-DUCTED HOODS)

1. Assemble the flue mounting bracket, adjusting outside width as shown. See Figure 7.

2. Carefully center the mounting bracket directly over the range hood location.

3. Secure the bracket assembly to the ceiling using (2) 4.8x38mm mounting screws and drywall anchors (Fig. 8). Make sure

the bracket is pushed into the corner, tight against the wall and centered over the hood.

FLUE MOUNTING BRACKET

9-13/16”

(248.6 mm)

FIG. 7

3.9 x 6 mm

FLAT HEAD

BRACKET SCREWS

FIG. 8

4.8x38mm

MOUNTING SCREWS

DRYWALL ANCHORS