Enviro 50-1574 - Manual (Page 15)

15
2 ft
(61 cm)
Rain Cap (ensure cap
is at least 3ft (91cm)
above the roof at the
lowest point)
Roof Flashing
Roof Rafter
Fire Stop with
Support Collar
Ceiling Joist
Vertical Vent Pipe
Clean Out Tee with
Pipe Adapter
EF 5
NOTE: All vent sections must
maintain 3 inches (7.6 cm)
clearances to combustibles.
Installation
I
NSIDE
V
ERTICAL
I
NSTALLATIONS
:
1. Choose a stove location that is ideal. See the section “D
ECIDING
W
HERE TO
L
OCATE YOUR
P
ELLET
A
PPLIANCE
.”
2. Place a non-combustible hearth pad where necessary.
Figure 14: Inside Vertical Installation.
3. Place the unit on the hearth pad (if
installed on a carpeted surface) and
space the unit in a manner so when
the pellet vent is installed vertically,
it will be 100mm (4”) away from a
combustible wall.
4. Locate the center of the fresh air
intake pipe on the unit. Match that
center with the same point on the
wall and cut a hole about 40mm
(15⁄8”) in diameter.
5. Install the fresh air intake pipe.
6. Install the tee with clean out.
7.
I nstall the pellet vent upward
from there. When you reach the
ceiling, make sure that the vent
goes through the ceiling fire stop.
Maintain a 100mm (4”) distance
to combustibles and keep attic
insulation away from the vent pipe.
Maintain an effective vapor barrier.
8. Finally, extend the pellet vent to go
through the roof flashing.
9. Ensure that the rain cap is
approximately 900 mm (36”) above
the roof.
O
UTSIDE
V
ERTICAL
I
NSTALLATIONS
:
To accomplish a outside vertical pipe installation, follow steps 1 through 5 in the “I
NSIDE
V
ERTICAL
I
NSTALLATIONS
- F
REESTANDING
” section and then finish it by performing the following (refer to Figure 15).
1. Install a tee with clean out on the outside of the house.
2. Install vent pipe upward from the tee. Make sure that you install support brackets to keep the vent
straight and secure.
3. Install ceiling thimble and secure the flashing as you go through the roof.
4. Ensure that the rain cap is approximately 900 mm (36”) above the roof.