beautypg.com

Echo SHC-265 User Manual

Page 27

background image

S

haft

h

edge

C

lipper

27

O

peratOr

'

S

M

anual

s

torage

WARNING

During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear

of flammable debris during transportation or when storing, otherwise serious personal injury may result.

Long Term Storage (over 30 days)

Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage mainte-

nance which includes the following:

1. Store unit in a dry, dust free place, out of the reach of children.

WARNING

Hedge Clipper blades are very sharp. Touching them may lead to severe personal injury. Avoid touching blades

whenever possible, and always wear gloves to protect hands.

dANGeR

Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark, otherwise serious per-

sonal injury may result.

2. Place the stop switch in the “OFF” position.

3. Remove accumulation of grease, oil, dirt and debris

from exterior of unit.

4. Perform all periodic lubrication and services that are

required.

5. Apply clean oil to the entire length of the blade. Be

certain the blade bolts are lubricated.

6. Install blade cover on blades.

7. Tighten all the screws and nuts.

8. Drain the fuel tank completely and pull the recoil

starter handle several times to remove fuel from the

carburetor.

9. Remove the spark plug and pour 7cc (1/4 oz.) of

fresh, clean, two-stroke engine oil into the cylinder

through the spark plug hole.

A. Place a clean cloth over the spark plug hole.

B. Pull the recoil starter handle 2-3 times to

distribute the oil inside the engine.

C. Observe the piston location through the spark

plug hole. Pull the recoil handle slowly until

the piston reaches the top of its travel and leave

it there.

10. Install the spark plug (do not connect ignition cable).

IMPORTANT

Always store and transport hedge clippers in a stable, horizontal position. Support gear case and cutting blades to

prevent excessive flexing, which may cause damage to these components. Always install blade cover when transport-

ing or storing unit.