beautypg.com

Gear housing assembly / drive shaft, Operation, Fuel – Echo SHC-265 User Manual

Page 11

background image

S

haft

h

edge

C

lipper

11

O

peratOr

'

S

M

anual

NOTICE: Use of unmixed, improperly mixed, or fuel older than 90 days, (stale fuel), may cause hard starting, poor

performance, or severe engine damage and void the product warranty. Read and follow instructions in the Storage

section of this manual.

fuel

gear

housIng

assembly

/

drIve

shaft

NOTE

Hedge Clipper Blades are very sharp. Wear gloves to protect

hands.

1. Remove locating bolt (A) and loosen clamping bolt (B).

2. Remove vinyl cap from drive shaft.

3. Slide Gear Housing Assembly onto Drive Shaft. Be certain the

Flex Drive Shaft engages the hole in Driver Gear.

IMPORTANT

Flat edge of washer (C) must be against drive shaft.

4. Align locating hole in gear housing with locator hole in drive

shaft.

5. Install locating bolt (A). Tighten clamping bolt (B).

A

b

C

o

peratIon

WARNING

Operation of this equipment may create sparks that can start fires around dry vegetation. This unit is equipped with

a spark arrestor and a spark arrestor may be required. The operator should contact local fire agencies for laws or

regulations relating to fire prevention requirements.

WARNING

Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all

openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop

before removing obstructions, clearing debris, or servicing unit.