beautypg.com

Throttle linkage and ignition leads – Echo SHC-265 User Manual

Page 10

background image

10

C

d

f

G

H

e

A

b

b

NOTE

Gear Housing must be aligned properly with engine. Aligning cen-

ter locating hole in driveshaft housing with center drive shaft bolt

(A) provides correct alignment.

5. Tighten two (2) drive shaft clamp bolts (B) securely.

6. Route throttle linkage and ignition lead assembly along shaft and

clip as shown.

H

throttle

lInkage

and

IgnItIon

leads

1. Close choke and remove air filter cover.

2. Place throttle linkage (C) through adjustment fixture (D) and install

wire end into large carburetor throttle swivel hole (E). Check

throttle for freedom of movement and that wide open throttle / low

idle extremes are adjusted properly. The throttle linkage must be

adjusted by moving the adjustment fixture (D). Consult with your

Echo Dealer for correct adjustment procedure.

3. Connect 2 ignition stop leads (F, G) from throttle cable tubing to 2

ignition leads (F, G) on engine.

CAUTION:

Assure ignition terminals are completely covered by clear plastic

sleeves.

4. Secure ignition leads against engine housing with clip (H).

5. Install air filter and cover.